Mark three points on a photo of your wall
Take a straight-on photo that shows the whole area, including the skirting board, nearby furniture and the socket you intend to use. On the photo, draw the proposed outline of the sign. Then mark three points: where you’d like the cable to leave the sign, where the power adaptor could sit and which socket you’ll use.
The featured mock-up shows a route that heads to the right of the sign, then drops to an adaptor on a console. A separate mains lead runs from the adaptor to the socket. Try sketching a second route on your own photo if the first would leave a cable hanging across an open gap or running past a cupboard door.
Measure the two cable runs separately
Use a tape measure on the wall and follow the route you drew. If the cable will go sideways before dropping down, measure each section and add them together. Make a note of the two runs:
- Sign to adaptor: Start at the preferred cable exit on the sign and follow the route to the spot where the adaptor would sit.
- Adaptor to socket: Start at the adaptor and follow the route the mains lead would take to the socket.
Check the route with the furniture in its usual position and any nearby doors or drawers open. Leave some room at each end so the leads can reach their connections without being pulled tight. Pick an adaptor spot you can still get to once the room is set up.
Send the marked photo before you order
Send the photo with both route lengths and mark your preferred cable exit as you see it when facing the wall. Ask the supplier to confirm where the cable can exit on your chosen design and the usable lengths of both leads. If one run is too short, the measurements show which lead needs extra reach. Ask what’s compatible with your sign before buying an extension.
If there’s a design proof, check the cable exit against your photo before you approve it. A move from one side of the sign to the other changes where your measurement starts. Once the route is agreed, use our neon sign installation guide to plan the mounting and fixings.