Start with the OUTPUT line
Turn the adaptor over and look for the line marked OUTPUT. The voltage tells you what the adaptor supplies to the sign. The amp rating tells you how much current the adaptor is rated to deliver. Multiply the DC output voltage by the rated output current to find the rated output in watts.
Take the Neon Now 12 V, 5 A power adaptor as an example. Its published specification gives a rated output of 12 V × 5 A = 60 W. A sign connected to that adaptor draws the current it needs at its current brightness setting. The 60 W figure describes how much power the adaptor can supply on the low-voltage side.
The INPUT line describes the mains side of the adaptor. It has its own ratings. For the electricity your setup actually uses, take a reading with the sign switched on.
Measure the watts at the wall socket
Use a plug-in electricity monitor that displays watts and can read small loads. Plug the monitor into the wall socket, then plug your sign’s usual adaptor into the monitor. Leave the dimmer connected as you normally use it.
- Switch the sign on at full brightness. Once the reading settles, write down the watts.
- Set the sign to the brightness you normally use and take another reading.
- Record the brightness setting alongside each number so you can repeat the check later.
The monitor measures the whole setup at the socket, including the power the adaptor uses to convert mains electricity to low-voltage DC. If you’re checking electricity use over a full evening or a working day, use the monitor’s kilowatt-hour (kWh) mode for that period. Watts show the power at a given moment. Kilowatt-hours add up the electricity used over time.
Ask for the number that fits your setup
If you’re checking a sign before ordering, ask for the design’s expected power draw at full brightness and whether the figure comes from a measurement or an estimate. Ask where it was measured, too. A reading at the wall includes the adaptor, while a low-voltage reading taken at the sign describes the load at that point.
If you’re planning to use a sign away from a socket, see our guide to battery-operated LED neon signs for compatibility and runtime.